Question: How Do I Adjust The Seat On A Santa Cruz?

Should bike seat be higher than handlebars?

As a general rule of thumb, you want the top of the handlebar about as high (or higher than) the saddle, unless you’re a sporty rider looking to ride fast. You can change the height of the handlebar by moving the stem up or down the steerer tube.

How do I know if my saddle is too low?

If you go too high, you’ll notice you rock on the saddle or feel a strain at the back of the knee. Pedalling will cease to be smooth and circular, and you may feel your snatching at the bottom of the stroke. If you go too low, you’ll feel compression at the front of the knee.”

How do you adjust the angle of a chair seat?

How to Adjust the Tilt on an Office Chair

  1. Sit on your office chair with your feet flat on the floor.
  2. Find the tilt adjustment knob for your office chair beneath the seat pan.
  3. Push the tilt adjustment down, tilt the seat back and release the knob.

How do you set a saddle setback?

Determining Saddle Setback Move the saddle forward or backward so your knee is over the pedal spindle when the crank is in the 3 o’clock position. Again, this is a good starting point, and then you can adjust your cleats fore and aft as needed. Use your thumb to feel the ball of your foot on the inside of your shoe.

You might be interested:  Often asked: How Far Is Santa Cruz From Yosemite?

Why does my dropper post go down when I sit on it?

On smaller frames with internal routing for your dropper, lowering the seat post too far can cause the cable and housing to become kinked. Just like your derailleur cable, over time your cable will settle in to your housing for your dropper seat post which causes the cable to loosen.

How important is a dropper post?

The biggest reason you need a dropper post is to quickly go between seated pedaling and standing to navigate steep drops or jumps. Enduro riders need to be able to pedal hard over long distances and varied terrain, but they also need to clear very technical terrain so they get the most use out of a dropper post.

What cable do I need for a dropper post?

For reference, gear outer cable is often 5mm in diameter (some fancy gear outer is 4mm). Dropper Pro is 4mm diameter. Regular gear inner cables are 1.2mm thick. Dropper Pro System inner cables are 0.8mm thick.

Is 125mm dropper post enough?

The 125mm is more than enough to get the saddle completely out of the way. I mean if you’re someone with long legs and a 125mm would barely get your saddle below the barthen yeahyou’ll probably need more drop.

Can you limit a dropper post?

For dropper posts the limiting factors are same, plus one more limit is the presence of a seatpost collar which is thicker than the rest of the outer tubing. You should try lowering your post as low as it goes in the frame.

Leave a Reply

Your email address will not be published. Required fields are marked *